strings u-boot.bin | grep -i "aes" Look for key arrays in rodata section.
This article explains what it is, how it works, and practical methods to decrypt and analyze it. A normal, unencrypted UImage header (64 bytes) looks like this:
| Offset | Size | Field | Example Value | |--------|------|---------------|-------------------| | 0x00 | 4 | ih_magic | 0x27051956 | | 0x04 | 4 | ih_hcrc | Checksum | | 0x08 | 4 | ih_time | Timestamp | | 0x0C | 4 | ih_size | Data size | | 0x10 | 4 | ih_load | Load address | | 0x14 | 4 | ih_ep | Entry point | | 0x18 | 4 | ih_dcrc | Data checksum | | 0x1C | 1 | ih_os | OS type | | 0x1D | 1 | ih_arch | Architecture | | 0x1E | 1 | ih_type | Image type | | 0x1F | 1 | ih_comp | Compression | | 0x20 | 16 | ih_name | Image name | encrypted hilink uimage firmware header
Key for E3372 (v1): 0x4A,0x6F,0x6B,0x65,0x72,0x73,0x43,0x6F,0x6D,0x65,0x74,0x21,0x2A,0x2A,0x2A,0x00 Key for B310: Derived from serial number + static seed : Modern HiLink devices (2020+) use device-unique keys, making extraction harder but not impossible via hardware glitching. 3.3 Header Structure After Decryption Once decrypted, the header reverts to a standard UImage header with one twist: the ih_name field often contains a secondary signature or a plaintext marker like "SECURE_HILINK_V1" .
1. Introduction Huawei’s HiLink protocol powers millions of routers, LTE dongles, and IoT gateways. While standard U-Boot images (UImages) use a well-documented header structure ( struct image_header ), recent HiLink firmware variants employ an encrypted header layer —a deliberate obfuscation to prevent third-party firmware modifications, analysis, and repacking. strings u-boot
If the magic appears, you have the correct key. The rest of the firmware may be encrypted in blocks. Many HiLink images encrypt only the header + first block. The remaining data may be plain or compressed. After decryption, run:
cipher = AES.new(key, AES.MODE_CBC, iv) dec_header = cipher.decrypt(enc_header) While standard U-Boot images (UImages) use a well-documented
binwalk -E firmware.bin If the first 1 MB shows high entropy (>0.98) with no known signatures, suspect encryption.
magic = struct.unpack(">I", dec_header[0:4])[0] if magic == 0x27051956: print("Decryption successful") with open("dec_header.bin", "wb") as out: out.write(dec_header) The encrypted HiLink UImage header is a modest but effective speed bump against casual analysis. For a determined reverse engineer, it adds a few hours of work—identifying the key source, decrypting, and repacking. However, modern per-device keys and additional signature checks make widespread third-party firmware creation impractical.
with open("firmware.bin", "rb") as f: enc_header = f.read(4096)
Check for HiLink markers: