Ma112 Usb To Uart Bridge Driver Apr 2026

sudo modprobe usbserial vendor=0x1a86 product=0x7523 # Example VID/PID # Or use the dedicated module: sudo modprobe ch341 Add your user to the dialout group:

sudo usermod -a -G dialout $USER # Log out and back in ma112 usb to uart bridge driver

screen /dev/ttyUSB0 115200 macOS does not include native MA112 drivers. You must use a third-party driver, typically a wrapper around the open-source ch341 driver. The MA112 driver supports arbitrary divisors

| Baud Rate | Throughput (kB/s) | CPU usage (peak) | Latency (ms) | |-----------|------------------|------------------|--------------| | 9600 | 0.96 | <1% | 8 | | 115200 | 11.5 | 2% | 2 | | 921600 | 89.2 | 12% | 0.8 | Among the myriad of chips from Silicon Labs

$ dmesg | grep -i ma112 [ 1234.567890] usb 1-2: new full-speed USB device using xhci_hcd [ 1234.712345] usbserial: USB Serial support registered for MA112 [ 1234.712456] ma112 1-2:1.0: MA112 converter detected [ 1234.715678] usb 1-2: MA112 converter now attached to ttyUSB0

./ma112_eeprom --vid=0x1234 --pid=0x5678 --serial=ABC123 Warning : Changing VID/PID breaks driver matching unless you update the .inf file accordingly. The MA112 driver supports arbitrary divisors. On Linux, use setserial :

1. Introduction In the ecosystem of embedded systems, IoT development, and legacy hardware interfacing, the USB-to-UART bridge is an indispensable tool. Among the myriad of chips from Silicon Labs (CP210x), FTDI (FT232), and Prolific (PL2303), the MA112 occupies a specific niche. Often found on low-cost development boards, GPS modules, and industrial sensor interfaces, the MA112 is a highly integrated bridge chip designed for simplicity and cross-platform compatibility.