Mitsubishi Msy-ge10va Service | Manual

This text is for informational purposes only. Always refer to the official Mitsubishi Electric Service Handbook (OCH###) for proper safety procedures, wiring verification, and troubleshooting. Service Manual: Mitsubishi MSY-GE10VA Type: Wall Mounted, Heat Pump, Inverter Split System Refrigerant: R410A Power Supply: 230V ~ 50Hz (Single Phase) 1. Technical Specifications | Parameter | Cooling | Heating | |-----------|---------|---------| | Capacity (Min-Rated-Max) | 1.0 kW – 2.5 kW – 3.2 kW | 1.1 kW – 3.2 kW – 4.0 kW | | Power Input | 0.48 kW | 0.70 kW | | Running Current | 2.2 A | 3.1 A | | EER/COP | 5.21 | 4.57 | | Moisture Removal | 1.2 L/h | – | | Airflow (Low-Mid-High) | 312 – 366 – 486 m³/h | 330 – 390 – 516 m³/h | | Operating Range (Outdoor) | -10 to 46°C DB | -15 to 24°C WB | | Noise Level (Indoor) | 21 – 29 – 40 dB(A) | 21 – 31 – 41 dB(A) |

| LED Indication (Operation/Timer) | Error Code | Cause | Solution | |----------------------------------|------------|-------|----------| | 1 blink / 1 blink | P1 | Indoor room thermistor open/short | Check RT11 (2–15 kΩ) | | 1 blink / 2 blinks | P2 | Indoor pipe thermistor open/short | Check RT12 | | 2 blinks / 1 blink | E6 | Indoor/Outdoor communication error | Check TB3-3 voltage (pulsed 0–24V). Verify wiring polarity. | | 3 blinks / 1 blink | E0 | Outdoor control board – EEPROM error | Replace outdoor PCB | | 3 blinks / 2 blinks | E1 | Outdoor thermistor (RT61/62) fault | Check resistance vs temp chart | | 4 blinks / 2 blinks | F3 | Discharge pipe temp > 110°C | Low refrigerant, LEV stuck closed, or overcharge | | 5 blinks / 1 blink | F1 | High pressure switch triggered | Blocked outdoor coil, fan failure, overcharge | | No blinks / 2 blinks | U2 | Compressor overcurrent / lock | Check compressor windings, inverter module | mitsubishi msy-ge10va service manual