Uis8141e Firmware Page

# Dump SPI flash via I2C (if supported) python uis_dump.py --bus 1 --addr 0x42 --output backup_fw.bin Or using SPI programmer:

# Re-read firmware version v4l2-ctl -d /dev/video0 --get-ctrl=firmware_version v4l2-ctl -d /dev/video0 --stream-mmap --stream-count=100 --stream-to=/tmp/depth.raw uis8141e firmware

If version matches expected and no CRC errors appear in dmesg , flash is successful. | Symptom | Likely Cause | Solution | |---------|--------------|----------| | No /dev/video* | Wrong firmware for USB PID/VID | Reflash matching USB descriptor firmware | | Depth values all zero | Firmware missing calibration | Upload factory calibration (separate .cal file) | | Sensor resets repeatedly | SPI flash corruption | Erase flash, reflash, verify checksum | | I2C error after update | Bootloader stuck | Pull BOOT pin low for 2s during power-on | 7. Backup Current Firmware Before updating, always back up the existing firmware: # Dump SPI flash via I2C (if supported) python uis_dump